Glass & Stone Mosiac Kitchen Backsplash Tile Install By: Don Of All Trades

photo 2

Photos courtesy  Don Of All Trades

There’s nothing more exciting than adding  upgrades to your home like this Glass and Stone Mosaic Kitchen Backslash install our team at Don Of All Trades Professional Home Maintenance Services recently completed for our client.  These home owners picked their own choice of colour and style of tile. I have to say, the end result is SPECTACULAR!

photo 5

Product:  Glass and Stone Mosaic Wall Tiles

Up for a DIY challenge? Here’s some important steps to remember BEFORE you start the installation process.

Important Information To Remember

  • Make sure the surface is level and clean prior to installation.
  • If applying mosaic tile on gypsum, it is important to apply a coat of primer prior to beginning your mosaic wall tile installation.
  • Always check all the purchased boxes of tiles before starting. I have been in situations where clients thought what they purchased was all the same tile when in fact what they brought home was 3 different types of tile.  This step saves everyone involved  a lot of time and aggravation.
  • Inspect each tile prior to installation.
  • When installing tiles, mix and match tiles from different cartons for a natural look.
  • If you are installing mosaic wall tiles in a shower, it is necessary to install a waterproof membrane.
  • Install any trim or profile strips before installing the mosaic wall tile.
  • Modified thin-sets are generally appropriate for mosaic wall tile installations. Pre-mixed thin-sets are not appropriate for bathroom installations, and should not be used for mosaics featuring glass wall tiles.
  • Follow all manufacturer’s instructions when applying modified thin-set and grout.

photo 4

Photos courtesy  Don Of All Trades

So Here’s What We Did

  1. First step was to come up with a plan of where these tiles were going to be placed on the walls.

With the plan in place, we began our kitchen back-splash install by adding the first tile in the closest centre point of the wall, keeping in mind that the last tiles in each row would be wider than half a tile.

Tip: Always stop and check to make sure your tiles are level.

photo 3

Photos courtesy  Don Of All Trades

There were some moments in this installation process where we had to cut a mosaic tile sheet from the back with a utility knife. With this type of tile, a wet saw with a  diamond blade was used to cut through the tiles.

photo 04

Photos courtesy  Don Of All Trades

Setting material was  applied to substrate while using the notched side of a V-Notched trowel. Using the flat side of trowel, we smoothed out all ridges to achieve a consistent, even (1/8 inch) coverage.

Now comes the fun part!

We applied glass  mosaic sheets, mesh-side down, firmly into the freshly spread setting material while mixing and matching from assorted sell units to achieve a consistent variation. Using a rubber float to gently press the tile into the adhesive to ensure  a complete contact. Spacers where also used to maintain a set distance between the mosaic tile sheets.

photo 4

Photos courtesy  Don Of All Trades

We marked measurement marks on the back of the sheets of tile in order to install the mosaic tile around  the light fixtures and electrical sockets.  Once the tiles where in place, we then measured the gaps around the sockets and used leftover pieces to fill in the gaps.

Spacers were removed once the adhesive had set.  Tiles were wiped with a clean sponge to remove any residual adhesive.

A premium penetrating sealer is recommended for a natural look referred by the manufacturers instructions  and was applied onto the stone only.

photo 05

Photos courtesy  Don Of All Trades

After 24 hours, a mix of non-sanded tile grout was applied with a rubber float. Afterwards, the grout was evened out by wiping the tile with a wet sponge in a circular motion. Residual grout was cleaned with a clean sponge within 5-10 minutes of grout application.

After 12 hours, any remaining haze was polished off using a dry cloth.

 

finished backsplash 16

Glass and Stone  mosaics have been used to beautify buildings and homes for centuries. They can be incorporated into many designs to produce a stunning result.

Click On Our Business Card To Find Out More About Our Services!

dan1

For more information or to post a comment : please visit our links below:

Website – http://www.donofalltrades.ca/

Facebook – https://www.facebook.com/donofalltrades.info

Twitter – https://twitter.com/donofalltrade

Advertisements

2 thoughts on “Glass & Stone Mosiac Kitchen Backsplash Tile Install By: Don Of All Trades”

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s